Whirlpool ADG937/1S Error

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG937/1S Error

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 8, 2006 at 10:41 am #16998
    Markty
    Participant

    The above machine has a fault whereby the 3 programme indicator lights flash on and off in sequence and the machine will not do anything.
    I cannot reset it from the Start switch either and the start light will itself flash on and off after a while.
    I have checked the basics like the door switch and the salt level but I fear it may be a terminal control board.
    I’d appreciate any ideas out there so I do not have to buy a new machine at this time.

    April 8, 2006 at 8:10 pm #172483
    Dave_Conway
    Participant

    Re: Whirlpool ADG937/1S Error

    I think you’ll need an engineer for this one to be honest, all three lights flashing is not a recognised error code. Unless the start light is flashing a sequence as well possibly ?

    Check the repairs@ link below 🙂

    Dave.

    April 9, 2006 at 8:14 am #172484
    Markty
    Participant

    Re: Whirlpool ADG937/1S Error

    Thanks Dave,

    In case it does help, the Start light repative sequence is about 2 seconds ON and about 0.5 second OFF.
    When it first stopped working it left a pool of water in the machine that we could not pump out.

    Mark. 😕

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.