- This topic has 1 reply, 2 voices, and was last updated 20 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
My WM has ceased to rotate/spin. I can spin it manually. The following error code appears (slow/hold) 1000 0100. Can anyone help?
Re: fisher and paykel smartdrive 703 – no spin
Tricky one……. the computer is picking up excess current and is shutting the motor down.
Causes: Short circuit in the wiring to the motor, short in the motor stator windings, even the rotor position sensor can cause this fault. If all the above are OK, it’s the motor controller board playing up.
Power off before going underneath – if you’re not sure, get pro help – this is a difficult one to get right.
Regards,
Penguin45.
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.