Whirlpool ADG 710 dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG 710 dishwasher

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 19, 2006 at 11:23 am #17220
    Jmorg
    Participant

    We have recently moved into a new house that came with a dishwasher (whirlpool ADG 710). When the dishwasher was put on the water didnt heat up and the cycle got stuck and so lasted until we eventually moved it on. We have tested the element and it works fine. We have been advised it could be the thermostat or the cut off switch. Any other suggestions?

    I’m trying to get hold of a thermostat but cant find one anywhere? I dont know how much one will cost so dont know if its worth just buying a new washer?

    Can anybody advise what the cut off switch might look like or does anybody have a drawing of where it is located?

    Thank you. 😀

    April 19, 2006 at 9:34 pm #173382
    Dave_Conway
    Participant

    Re: Whirlpool ADG 710 dishwasher

    The manual reset thermostat has tripped I expect, normally caused by blocked spray arms or poor water circulation, look for a red button 😉

    Power off when checking :zap:

    Dave.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.