Teka dishwasher fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Teka dishwasher fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 24, 2006 at 5:27 pm #17348
    cornwell40
    Participant

    Have a fault code on this machine ADW659F1VR02 dishwasher.
    The layout looks familiar but I can’t remember who’s it is. Mains switch on RHS Leds in a row on left.
    The fault is that the sump clearing goes ok, starts to fill then we get the first three leds flashing.
    Any ideas?


    Tony C

    April 24, 2006 at 6:07 pm #173890
    admin
    Keymaster

    Re: Teka dishwasher fault

    Hi cornwell40

    Tis a SMEG,I can check in the morning for you unless you can have a look at the technical fault codes on the forum.

    bryan

    April 24, 2006 at 7:14 pm #173891
    cornwell40
    Participant

    Re: Teka dishwasher fault

    Chris wrote

    E7 – 1st, 2nd, 3rd flashing – flow meter detected when not fitted – reset required

    😯
    How do you reset it?

    Tony C

    April 24, 2006 at 8:20 pm #173892
    Penguin45
    Participant

    Re: Teka dishwasher fault

    Power off. Switch on and within 3 seconds press start 4 times. Switch off, count to ten, switch on and run the rinse programme.

    Chris.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.