Beko D3421FS stopping mid cycle

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Beko D3421FS stopping mid cycle

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • April 28, 2006 at 2:13 pm #17452
    nightflyer
    Participant

    During the night my dishwasher stopped towards the end of the main wash cycle 4. I was aware that it had been making the same sounds for over an hour. When I checked it appeared as if the pump was continually pumping out while the water was coming in. I turned it off until this morning, then I turned the programmer forward a few clicks until the pump stopped and the machine filled. The cycle then continued to the end of the programme. Can I assume the programmer is at fault and has anyone any idea of the cost and complication of fitting a replacement. We are about to move having sold our house with the white goods … aint that just Sod’s Law ? Any help or advice would be much appreciated.

    April 28, 2006 at 11:19 pm #174429
    Penguin45
    Participant

    Re: Beko D3421FS stopping mid cycle

    The fault you describe could be the programme controller. However, consider that there is a flood protection system attached to the appliance, this may be cross linked with the water level control system.

    Difficult to be sure – try running the appliance a few times successively – if it stops at exactly the same point every time with exactly the same symptons, the timer is a reasonable bet.

    Click the link below for a UKW engineer if you’re not sure how to proceed, power off for any investigations beyond observation.

    Regards,
    Penguin45.

    April 29, 2006 at 2:54 pm #174430
    nightflyer
    Participant

    thanks for taking the trouble to reply … I have run the dishwasher again and it appears to be ok … will try it again today & let you know … Regards, Nightflyer

    May 1, 2006 at 8:31 am #174431
    nightflyer
    Participant

    nightflyer wrote:thanks for taking the trouble to reply … I have run the dishwasher again and it appears to be ok … will try it again today & let you know … Regards, Nightflyer

    I have run the dishwasher a few times now and it seems perfectly ok. Perhaps it was some querk or other although I am now wondering if perhaps I started the cycle beyond the start mark (I dont see too good these days) which may have caused it to run with no water or too little water. Anyway, sorry to have bothered you and thanks again for your prompt reply

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.