hotpoint wd440

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wd440

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • May 2, 2006 at 12:41 pm #17517
    robbo1973
    Participant

    hi cust complaint, fills tumbles then starts to pump out and on/off flashes fast and drying high heat and rinse hold flash slowly. going out to this tomorrow any ideas. cheers chris

    May 2, 2006 at 4:30 pm #174653
    iadom
    Moderator

    Re: hotpoint wd440

    Error F10. Pressure switch not sensing. check switch and module connections.

    May 2, 2006 at 9:41 pm #174654
    robbo1973
    Participant

    Re: hotpoint wd440

    thanks very much going out tomorrow should be straight forward 😆 .are these fault codes available on this site i have checked known fault codes but none listed for newer machines.

    May 2, 2006 at 10:08 pm #174655
    iadom
    Moderator

    Re: hotpoint wd440

    I will get a round tuit. 😉 In fact as the wife is watching Lost I may do it now. 🙂

    May 3, 2006 at 7:32 pm #174656
    robbo1973
    Participant

    Re: hotpoint wd440

    thanx very much it would be helpful and it was dodgy contact on module cheers chris. 😆

    May 3, 2006 at 7:48 pm #174657
    iadom
    Moderator

    Re: hotpoint wd440

    robinsonrobbo wrote:thanx very much it would be helpful and it was dodgy contact on module cheers chris. 😆

    I did promise to do it last night, I am a man of my word. 😉

    May 4, 2006 at 4:38 pm #174658
    robbo1973
    Participant

    Re: hotpoint wd440

    nice one got them should help in the future 😀

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.