F & P GW603AU error code

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F & P GW603AU error code

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 2, 2006 at 1:29 pm #17519
    hyper_sven
    Participant

    Hi,
    I have a F & P GW603AU that was purchased in 1994 and has not missed a beat until now.
    Error code 0000 1011 is being displayed accompanied with constant beeping.
    This occurred during a regular wash after first rinse cycle.
    Can’t get it to do anything now except go into diag mode.
    I have checked the pump and it is not jammed.
    I have blown air down the sensor tube – no water in there.

    Any insight would be greatly appreciated!

    May 2, 2006 at 7:47 pm #174661
    Penguin45
    Participant

    Re: F & P GW603AU error code

    Can’t add much to this:

    http://www.ukwhitegoods.co.uk/modules.p … ic&t=13957

    Regards,
    Penguin45.

    May 2, 2006 at 11:38 pm #174662
    hyper_sven
    Participant

    Thanks Penguin,

    I was hoping that the code meant something different on my model. 🙂
    The control module costs around AUD$213 plus delivery.
    That’s 1/3 the cost of replacing it with a GW612.
    Is it worth investing that amount of money in a 12 year old machine? Or should I just bite the bullet and buy a GW612?

    Regards,
    hyper_sven

    May 2, 2006 at 11:53 pm #174663
    Penguin45
    Participant

    Re: F & P GW603AU error code

    Reconditioned boards are available for considerably less……… 😀

    Check your PM box shortly.

    Penguin45.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.