- This topic has 1 reply, 2 voices, and was last updated 19 years, 11 months ago by
.
-
Posts
-
I have a problem with my Dyson DC07 (one of the root cyclone ones). The motor keeps cutting out after about 5 minutes when first used, and then you have to wait for a few minutes until it can be used and ten the motor cuts out every couple of minutes, as I think perhaps it’s overheating and there must be a thermistor on the windings.
I have reached the conclusion that I probably ned to replace the motor, so the question is where can I get one. Also is it the same motor as in all upright Dysons, or do the use different motors??
Thanks. 😕
Re: DYSON DC07
Different motors across the range….. The one you need is here:
http://www.ukwhitegoods.co.uk/modules.p … cts_id=210
The motor will be shutting down on the thermal cut-out, therefore the motor is running hot. It is air-cooled, so check for restrictions, condition of filters and the like. The cone section at the top of the dust bin is notorious for choking up.
HTH,
Regards,
Penguin45.
- You must be logged in to reply to this topic.