- This topic has 2 replies, 2 voices, and was last updated 19 years, 11 months ago by
.
-
Posts
-
The water does not seem to be getting hot on my dishwasher, I have put the dishwasher through the test program and the washer just keeps going on and on (the whole test process should take about 20 mins) I am wondering if anyone out there has any ideas what’s wrong.
Re: Hotpoint dc27p
It will either need a new Heater or Control Module? Click link below for someone in your Postcode area to take a look at it for you 😉
Re: Hotpoint dc27p
😕 Got home tonight, and managed to strip down the dishwasher, put my meter across the heater and measured 29 ohms – I suspect that such a value is ok. When I put the washer back together and tested it, I notice on the circuit diagram I have,a pressure switch in line with the heater and that is about it could this be anything to do with the fault? I have also found that the temperature sensor on the control module appears to be open circuit – again can anyone help me? 🙁
- You must be logged in to reply to this topic.