Whirlpool ADG 7340 error code 3

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool ADG 7340 error code 3

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 28, 2006 at 9:50 am #18112
    shaunglen
    Participant

    Hello, Can anyone help me with my whirlpool dishwasher? It seems to run the initial rinse cycle when you first turn the machine on, then the machine starts to pump but then starts to beep. the power light is flashing 3 short pulses followed by a long one. The 12 digit service code for this machine is 854234015820
    Thanks for your help.
    Regards, shaun

    May 28, 2006 at 2:53 pm #177743
    gegsy
    Participant

    Re: Whirlpool ADG 7340 error code 3

    You need to be looking in the heating circuit.
    Power off of course :plug:

    Greg

    June 1, 2006 at 4:43 pm #177744
    shaunglen
    Participant

    Re: Whirlpool ADG 7340 error code 3

    Thanks. It was the heater. Replaced it with no problems. can you tell me what all the 9 error codes are? unfortunately we did not get an instruction book with this machine and i havent been able to locate much about these on the internet. Thanks

    June 1, 2006 at 9:23 pm #177745
    gegsy
    Participant

    Re: Whirlpool ADG 7340 error code 3

    shaunglen wrote: can you tell me what all the 9 error codes are?

    Hi
    We are here to help but cannot give out verbatim engineer information.
    If you should in the future have any further problems please don’t hesitate to use this site again.

    Greg

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.