- This topic has 2 replies, 2 voices, and was last updated 19 years, 10 months ago by
.
-
Posts
-
It appears the Drain Pump has failed. However does antone know what control the pump and on what pins should I find the live feed when in empty mode. I assume the case has to be slip to gain access to the pump. Regards Peter
Re: Zanussi Jetsystem 1200 FJ 1295
Peter,
We will not advise you on how to perform “live” testing – please check the rules as outlined here:http://www.ukwhitegoods.co.uk/modules.p … pic&t=4359
Within these limitations, I can advise you of the following. Your machine uses an “Askoll” type pump, which is prone to the following faults:
1) Wear – set the machine to the drain programme and apply ear to front of casing. If you can hear a faint hum, there is power going to the pump motor, but it is not revolving.
2) Failure – the coils can overheat and blow – this is normally visible when the pump is inspected.Access – tip the machine back and get it from underneath – a lot less work.
A supply failure on this particular appliance would be most unusual.
We do advise you to cut the power when accessing the pump.
spares@ukwhitegoods.co.uk will be able to supply a replacement at a competative price if required.
Regards,
Penguin45.
- You must be logged in to reply to this topic.