- This topic has 2 replies, 3 voices, and was last updated 19 years, 9 months ago by
.
-
Posts
-
Model CN100T 31000216
On program 1,2,3,4 machine will do wash and rinses then the program selector will stop moving at the pump out before the fast spin, just stops and machine dead.
First thoughts it is on rinse hold but there is nothing in instruction book about rinse hold on these programs, and they are not delicate programs either.
If I switch machine off and advance selector to a slow spin on another program, then switch on, the machine pumps away and spins ok.
The selector is one of those motorised ones with contacts that select different resistances to tell the main pcb what program to do, I suspect a bad contact in the selector anyone had this before ?
Did a search on the forum for CN100 nothing found.
Thanks
MalcRe: Candy washing machine
I will get back to you on this once I can access the info on this beast? Right now I suspect module plug connector problems? But I will check it out ASAP and report any further thoughts and theories to you later! 😉
Re: Candy washing machine
I had one similiar, found in the end it was a sticky pump, would work ok when you put in on just pump and spin but after long wash the pump gets hot. The timer selector switch some of them can come apart so you can clean the contacts have done it myself, but watch out for the small springs etc inside dont fall out!!
If this model has the recirc hose above the pump then check for leaks onto pump have had this before shorting pump out.Steve
- You must be logged in to reply to this topic.