HOTPOINT WF240

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOTPOINT WF240

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 27, 2006 at 3:41 pm #18746
    7390ROBERTS
    Participant

    CAN ANYBODY TELL ME HOW TO RUN A DIAGNOSTIC CHECK FOR THIS MODEL PLEASE. IS IT THE SAME AS FOR THE W M A BOARDS.
    THE PROBLEM IS BOTH THE START/CANCEL BUTTON AND THE ON/OFF WERE STUCK IN. MACHINE IS DEAD APART FROM LED LIGHT.AM I RIGHT IN THINKING IT COULD BE THE PCB

    THANKS ROB

    June 27, 2006 at 4:25 pm #180234
    iadom
    Moderator

    Re: HOTPOINT WF240

    No diagnostics that you can run without the overpriced hardware key. Even that only gives you basic info that the neons also show. Full diagnositics only possible with an EMIT laptop and relevant software. 😥

    There are two PCB’s on this machine, the console module and the horrible Indecent Companies offering down in the base. The buttons themselves are separate from the board and it may be possible to free them off, they could just be gunged up with something that has been spilled over them.

    I would try to free the buttons first before trying a console PCB.

    Fault codes are in the known error codes thread.

    PS, please kill the CAPS LOCK 😉

    June 27, 2006 at 4:46 pm #180235
    7390ROBERTS
    Participant

    Re: HOTPOINT WF240

    Thanks for reply Iadom cleaned buttons there is damage to them causing them to stick in the customer is disabled so after reading other threads i am going to put new buttons on and test motor. I did not know that if motor problem it would not fill so i never checked motor on visit 😳 Am still new to this game and learning every day. I hope it is just motor brushes but when i tested insulation was ok

    Thanks again for info Rob

    June 27, 2006 at 5:52 pm #180236
    iadom
    Moderator

    Re: HOTPOINT WF240

    Would be very surprised if motor brushes had failed so soon unless the machine has been hammered.

    Part number for buttons is 1604589.

    Jim.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.