HPT THERMAL FUSE

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › HPT THERMAL FUSE

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 7, 2006 at 10:14 am #18971
    bazza500
    Participant

    I need a thermal fuse for a hpt wd63p part no. 1600870 but when I order it changes to hpt1605635 which I have been told is a suitable replacement but it doesn`t fit as the old one was rectangular and the new one is square. Does anyone have a hpt1600870 i can buy? or a grinder and a crowbar so i can fit the new one.

    Thanks, barrie

    July 7, 2006 at 10:21 am #181136
    ANDYVIVO
    Participant

    Re: HPT THERMAL FUSE

    have checked the stock and we have only the old style at the moment.

    Regards Andy

    July 7, 2006 at 12:01 pm #181137
    Dave_Conway
    Participant

    Re: HPT THERMAL FUSE

    Why does it matter if it’s square or rectangular, or does it fit into a recess on the dryer box (can’t remember now) ?

    If Andy (Masterpart) has the old style then that’s the one you need 🙂

    Dave.

    July 10, 2006 at 8:22 am #181138
    bazza500
    Participant

    Re: HPT THERMAL FUSE

    Dave the fuse fits between two metal bits which the spring for holding it in place goes under. The square one is too big to sit between these and therefore would not be on the heater box.

    July 13, 2006 at 1:00 pm #181139
    Martin
    Participant

    Re: HPT THERMAL FUSE

    bazza500 wrote:The square one is too big to sit between these and therefore would not be on the heater box.

    Simply bend the two side stops a little to accomodate the larger TOC (as shown below 😉 )

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.