Whirlpool G2P DWI

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool G2P DWI

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 20, 2006 at 10:45 am #19287
    *sauce*
    Participant

    Hope someone can help – put the dishwasher on last night and everything ok. Ten to twenty minutes into the programme i hear constant beeping and the start light is flashing (programme also jumped back to prewash according to the lights)
    Found out that the water had been cut off due to a leak in town and was off for five and a half hours. Left the dishwasher door open and switched off.
    Went to turn it on this morning and can’t use it. Still got flashing lights on start button, light on prewash and constant beeping.
    What do i do next???
    Is this fixable by ourselves or is it an engineer and expense job???
    Any help would be GRATEFULLY received
    Thank you!! 😆

    July 20, 2006 at 11:55 am #182544
    Dave_Conway
    Participant

    Re: Whirlpool G2P DWI

    It may have “remembered” the fault from yesterday, try holding the start button in for a few seconds after you’ve switched it on, turning the power off doesn’t always reset the PCB 🙂

    Dave.

    July 20, 2006 at 12:29 pm #182545
    *sauce*
    Participant

    Re: Whirlpool G2P DWI

    Thanks Dave just held the start button in and i’m back to working order – thanks so much for your help 😆

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.