Whirlpool AWM328/3 Stops on rinse

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool AWM328/3 Stops on rinse

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 4, 2006 at 8:52 am #19674
    legsthediver
    Participant

    When either “A” prog (rinse & spin) Or run on normal prog, the machine stops DEAD as soon as it takes the FINAL rinse fill.. this fill appears VERY low.. The rest of the cycle is perfect. NEVER seen this fault before.. ANY advice appreciated..

    August 4, 2006 at 9:08 am #184028
    Simon46
    Participant

    Re: Whirlpool AWM328/3 Stops on rinse

    Inlet valve coil intermittent when gets hot perhaps?

    S.

    August 4, 2006 at 10:35 am #184029
    legsthediver
    Participant

    Re: Whirlpool AWM328/3 Stops on rinse

    Does it straight away Simon….

    August 4, 2006 at 11:20 am #184030
    Martin
    Participant

    Re: Whirlpool AWM328/3 Stops on rinse

    Typical reasons are: Motor brushes? Air Bell blocked? Pressure Switch?

    August 8, 2006 at 8:50 am #184031
    legsthediver
    Participant

    Re: Whirlpool AWM328/3 Stops on rinse

    thanks to martin… Split brush caused prob..

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.