- This topic has 4 replies, 3 voices, and was last updated 19 years, 8 months ago by
.
-
Posts
-
Hi, Just ordered replacement board for WFO 2466 GB/o1. Part sent is a replacement Part no 443230. The part comes with an info sheet to code the board via a switch S10. Have coded it as I think it should be and the macine operates. The fault is that when the selector is set the led foe wash lights instead of the ready light. They are out of sync. Is this a coding fault?
Re: Bosch WFO 2466 GB/01 MODULE
Sounds like it they are a devil them tiny switches, I use a pin. Check the coding carefully again and make sure that none of the switches are half set.
Greg
Re: Bosch WFO 2466 GB/01 MODULE
I am sure they were ok. The machine has… Start / Reduced ironing / Rinse plus / wash plus. Could you confirm switch set up? Thanks
Re: Bosch WFO 2466 GB/01 MODULE
There is usually a link to the config table for us online, but can’t see one for your model. Can you email it over and then can tell you what you need to select.
Greg
Re: Bosch WFO 2466 GB/01 MODULE
There are TWO sets of dip switches that MUST be correctly coded.
The first bank of switches I think is S1 (there are about 7 or 8 on there).
The second bank only has 2 switches on it is S10. this bank tells the m/c if it’s Bosch, siemens or other.
I defo think you have coded it incorrectly 🙁
- You must be logged in to reply to this topic.