Diplomat ADP8112

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8112

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 20, 2006 at 5:18 pm #20119
    Collinsthejambo
    Participant

    My diplomat dishwasher shows the error code of the last 2 lights flashing. :rolls: It seems that all the dirty water has not been pumped out. I have tried re-setting but to no avail?

    Will it just be the pump?

    Cheers

    August 20, 2006 at 5:35 pm #185911
    Penguin45
    Participant

    Re: Diplomat ADP8112

    Yup, time out for drain. Reset the programme and start, you should hear the drain pump running. If no drain, but pump runs, you have a blockage after the pump – check hose to sink coupling as a starting point. If the pump is not running, it may well be blocked or have failed.

    Power off if going underneath to investigate.

    August 27, 2006 at 2:44 pm #185912
    Collinsthejambo
    Participant

    Re: Diplomat ADP8112

    I re-sett the dishwasher and the cycle started, ran so far and stopped again with a small amount of water (dirty) in the trap again.

    The same error shows (last 2 lights flash). 🙁

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.