DIPLOMAT ADP8234

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › DIPLOMAT ADP8234

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 5, 2006 at 10:44 am #20583
    al2015
    Participant

    Hi, I have searched the site but I can not find anyone else with this problem…………… . When I switch it on my Dipolmat ADP 8234 dishwasher I get the usual “PO” in the display window. This normally changes to whatever programme I select. I am now also getting another sign in the display window. This consists of a series of vertical lines with an x through them and “1/2” next to it. I am unable to change from programme “P0” and when I close the door, the machine beeps into life the pump starts but nothing else happens. Have you any ideas what the vertical lines and 1/2 sign means? Any advice or suggestions will be much appreciated.

    Thanks,

    AL

    September 5, 2006 at 7:47 pm #187597
    Penguin45
    Participant

    Re: DIPLOMAT ADP8234

    Crossed out lines is “no heat on dry”, 1/2 is “half load”. This is almost certainly a computerboard fault – it’s very expensive, so I would recommend a professional repair in order to avoid an expensive mistake!

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.