Hoover HW6316MUK Spins on wash

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HW6316MUK Spins on wash

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 5, 2006 at 3:48 pm #20594
    Simon46
    Participant

    Checked Tacho coil pulses when motor turned found module faulty. Which module does speed control The one at the top or the one at the back rear?
    What does the module do at the bottom? And does it have to be configured when a new one fitted?

    Regards
    S.

    September 5, 2006 at 6:14 pm #187637
    timdowning
    Participant

    Re: Hoover HW6316MUK Spins on wash

    On the previous hoover range, which is similar in design to this newer type, spinning on wash was normally due to the motor. Have you checked the insulation of the motor?

    From the few of these newer type washer dryers I have seen I thought the bottom module was for controlling the dryer?

    September 6, 2006 at 6:34 am #187638
    Simon46
    Participant

    Re: Hoover HW6316MUK Spins on wash

    Insulation OK on Ceset motor. Triac fault on board suspected. Board on Order now just need to know if it has to be configured.

    Regards
    S.

    September 6, 2006 at 7:12 am #187639
    Dave_Conway
    Participant

    Re: Hoover HW6316MUK Spins on wash

    Simon46 wrote:just need to know if it has to be configured.

    As long as you ordered part number 97923029 you’ll be OK 😉

    41003804 is the non configured PCB

    Dave.

    September 6, 2006 at 7:43 am #187640
    Simon46
    Participant

    Re: Hoover HW6316MUK Spins on wash

    Thanks Dave.

    S.

    September 11, 2006 at 10:39 am #187641
    Simon46
    Participant

    Re: Hoover HW6316MUK Spins on wash

    Watch out for thisone. Intermittent Short on Tacho killed new board. Ceset motor. metered out ok. 😥

    S.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.