Smeg DWI 710 (fault code anyone)

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Smeg DWI 710 (fault code anyone)

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 11, 2006 at 4:28 pm #20765
    Seamy
    Participant

    Been to one of these integrated Smegs (PIGS), there are five LEDS which signify faults, reading from Left to Right, lets call them L1 L2 L3 L4 & L5. On this machine LEDs L2, 3 & 4 are lit & L5 flashes. When i went to it there was still water in machine, it hadn’t emptied. How do you reset the fault? I got it to go by holding up float sw’ in base & it emptied. Then by a process of trying several sequences of pressing program & on/off buttons i got it to accept a new program setting & it seems to be up & running again. I don’t know what reset it or what was registered fault. I have removed non-return flap in sump as reccommended on here by the way.

    September 11, 2006 at 5:33 pm #188297
    Penguin45
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Something useful landing in your inbox……….

    Almost all problems with these relate to water level control or dodgy dispenser solenoids. Not sure about removing the non-return flap – it certainly needs to be lifted when the pipe behind it is rodded out – surprising how much crud accumulates in there.

    Chris.

    September 11, 2006 at 6:09 pm #188298
    goosegreen
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Hi Chris, Re: my post W/Pool/Ikea/Smeg DWF416 I was wondering if my problem is water level related. Any chance of sending me the info your sending Seamy?

    Cheers Goose

    September 11, 2006 at 6:43 pm #188299
    Seamy
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Says in the “Known Error ” section, look for non return flap & throw it away, now i realise everything on here is not gospel but i did exactly as it says on the tin.

    September 11, 2006 at 6:54 pm #188300
    Penguin45
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Done, Goose.
    Chris.

    September 11, 2006 at 9:54 pm #188301
    goosegreen
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Cheers :tup:

    Goose

    September 12, 2006 at 1:51 pm #188302
    Seamy
    Participant

    Re: Smeg DWI 710 (fault code anyone)

    Finally got to speak to someone at Smeg (in technical), quess what, its a falt that doesn’t exist. Likely to be either a bad soap dispenser solenoid or motor start capacitor.
    They throw up faults like this! So back i go to check those things…

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.