Hotpoint t/t 9404

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Hotpoint t/t 9404

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • September 13, 2006 at 12:46 pm #20825
    SWERV
    Participant

    I was wondering if anyone had a tripod/seal kit for the above machine in stock, that was willing to sell. I’ve tried all the normal suppliers and they’ve all said obselete 😥 .
    Regards
    Merv

    September 15, 2006 at 6:21 pm #188462
    allround
    Participant

    Re: Hotpoint t/t 9404

    pt 149090 is not obsolete according to part finder

    September 15, 2006 at 9:57 pm #188463
    SWERV
    Participant

    Re: Hotpoint t/t 9404

    Hi, I’ve tried partscenter, connect and Cds but they’ve all said obselete :cry:.
    Merv

    September 15, 2006 at 10:07 pm #188464
    iadom
    Moderator

    Re: Hotpoint t/t 9404

    HP13 (non gen) & HP14 ( gen 149090) are still listed from Qualtex, not sure how up to date that info is though.

    September 17, 2006 at 1:55 pm #188465
    SWERV
    Participant

    Re: Hotpoint t/t 9404

    Thanks Iadom, I’ve already tried them , but they’re both obselete
    Merv

    September 18, 2006 at 4:32 pm #188466
    bazza6
    Participant

    Re: Hotpoint t/t 9404

    Hi swerv, the seal on its own is still available part no is 143098, if that helps.

    baza

    September 18, 2006 at 6:16 pm #188467
    iadom
    Moderator

    Re: Hotpoint t/t 9404

    Just found a good tripod, but no seals etc. 😥

    September 18, 2006 at 7:12 pm #188468
    AMS
    Participant

    Re: Hotpoint t/t 9404

    You will not believe this but I was having a good clear out last week, picked one up still in it’s sealed packet, and threw it away saying “I’ll never need one of those again!” Typical!

    September 19, 2006 at 9:06 am #188469
    SWERV
    Participant

    Re: Hotpoint t/t 9404

    I’m sure I’ve done the same in the last couple of years! 😳
    Merv

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.