Diplomat ADP8332 FA & F2

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8332 FA & F2

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • September 13, 2006 at 5:59 pm #20835
    noelphobic
    Participant

    My dishwasher started bleeping during a cycle and when I opened it the error code F2 was flashing. After I messed around with it for a bit it started working again but now after a few minutes it bleeps and error code FA comes up. When it was in warranty I had a similar problem (possibly with different error codes though) and when the engineer came out he fixed it by pressing a few buttons. If it needs fixing and I have to pay for it then I will have to but I don’t want to call an engineer out and then find it could be fixed by pressing a series of buttons, which I could do myself!

    Any advice would be much appreciated. Nothing too technical though please! 😕

    September 13, 2006 at 6:13 pm #188509
    Penguin45
    Participant

    Water has leaked into the undertray of the machine and activated the flood protrection system. Possible cause is the water level control in the sump being dirty/sludged up. Draining the undertray will allow the machine to fill again, but you must identify and rectify the source of the leak.

    Power off, if investigating.

    Regards,
    Penguin45.

    September 13, 2006 at 6:16 pm #188510
    noelphobic
    Participant

    Re: Diplomat AD8332 FA & F2

    Thanks for your answer. Probably stupid question but how do I go about draining the undertray please?

    September 13, 2006 at 7:02 pm #188511
    Penguin45
    Participant

    Re: Diplomat AD8332 FA & F2

    Power off, towels down, tip it back.

    Penguin45.

    September 13, 2006 at 7:08 pm #188512
    noelphobic
    Participant

    Re: Diplomat AD8332 FA & F2

    I’ve just drained some of the water off. However, probably me missing something, but don’t see how you can tip a fully integrated dishwasher back?

    It’s beginning to look like I will need an engineer. I knew I should have extended the warranty!

    September 13, 2006 at 7:17 pm #188513
    Penguin45
    Participant

    Re: Diplomat AD8332 FA & F2

    Ah – it will have to come out of the housing……..

    If you’re not sure, please use the repairs@ link for a UKW engineer in your area.

    Penguin45.

    September 14, 2006 at 4:03 pm #188514
    noelphobic
    Participant

    Re: Diplomat AD8332 FA & F2

    I contacted the recommended repairer and they have told me they do not come out as far as my area! I don’t understand why they were recommended to me after putting my postcode details in!

    September 14, 2006 at 8:14 pm #188515
    kwatt
    Keymaster

    Hi Noel,

    Could you possibly PM me with the repairer’s name and your postal area and I’ll look into that?

    Thanks

    K.

    September 14, 2006 at 8:20 pm #188516
    noelphobic
    Participant

    Re: Diplomat AD8332 FA & F2

    I’ve just sent a PM. WIll look forward to hearing back from you.

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.