Question on LG motors

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Question on LG motors

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 15, 2006 at 9:54 pm #20896
    LightingElectrical
    Participant

    HI

    Have been fitting a tub rear with bearings for an LG WM1422OFD. My problem is the horseshoe shaped spacer that sits between the stator and drum rear. This was fitted on the original tub which had the large round metal backplate on it. The stator was mounted on this. If this is fitted with the new tub the bolts and stator fit ok but the pulley assy won’t fit. The splines can’t mate. If i try it without the horseshoe the bolts reach the end of their travel early leaving the stator loose but the pulley will fit. :rolls: Any clues?

    ron

    September 15, 2006 at 9:59 pm #188725
    pen0668
    Participant

    Re: Question on LG motors

    had some info on modified back pulley this is a dd system??

    September 15, 2006 at 10:33 pm #188726
    LightingElectrical
    Participant

    Re: Question on LG motors

    Yes, it’ s Direct Drive.
    Thanks for answering

    Ron

    September 16, 2006 at 2:15 am #188727
    bigsmokepiker
    Moderator

    Re: Question on LG motors

    Correct me if I,m wrong .Do you mean the Rotor

    Direct drives dont have a pulley

    September 16, 2006 at 6:56 am #188728
    BobHope
    Participant

    Re: Question on LG motors

    Hi
    you have mail.

    Bob.

    September 16, 2006 at 9:17 am #188729
    LightingElectrical
    Participant

    Re: Question on LG motors

    Thanks BobHope. Will let you know the outcome.

    Bigsmoke: Yes you are right. It is the Rotor not the Pulley.

    Ron

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.