- This topic has 9 replies, 4 voices, and was last updated 19 years, 6 months ago by
.
-
Posts
-
Does any one know which bearing kit fits a wma 54 my regular supplier says it is a standard wma bearing kit but these are about half the size
Re: WMA 54
Strange given the amount of Hotpoint machines I do that I have never seen any of the smaller bearings., although I know they exist. I don’t think there is a ‘kit’. I stand to be corrected but a drum rear and shaft may be your only alternative. You may source the right sized bearings but the seal may be a different matter.
No doubt one of the ‘official’ bods will clarify the situation.
Jim.
Re: WMA 54
I do a hell of a lot of wma series bearings and i have never seen these in them before i think i might just get a full wma tub and put it in rather than putting in a drum half from indesit.
but i would rather use a bearing kit if any does know
thanx though:)Re: WMA 54
i had one last week i phoned my mate at merloni he hadnt heard of it.
i changed drum rear and shaft.Re: WMA 54
i have just been having a good scoot about it, it has got a plastic bracket behind the door hinge, the wiring clips are straight from an indesit and the wholmachine just feels different tiny differences all over
right down to the fact that the heater wires actually come off without 5 men and an ass to pull at them 😆Re: WMA 54
mike1 wrote:i had one last week i phoned my mate at merloni he hadnt heard of it.
i changed drum rear and shaft.
Some mate, it is a well known fact that certain lower spin speed models were fitted with thinner drumshafts and smaller bearings. :rolls:Re: WMA 54
1200 and below have been fitted whith 30mm shafts, above 1200 are 35mm shafts, hope this hepls. jj
Re: WMA 54
Hi jj, is there a bearing kit for these smaller shaft/bearing assy’s or do you replace with the standard kit?
Jim.
- You must be logged in to reply to this topic.