- This topic has 3 replies, 2 voices, and was last updated 19 years, 7 months ago by
.
-
Posts
-
Hi,
I am getting a F13 code when running a drying cycle. The 3 thermostats have been replaced after I was getting F8/F10 codes. Can anyone advise what else might need replacing? Or have any suggestions?
EdRe: Hotpoint VTD65A Tumble Dryer
Rear NTC sensor problem. Can be sensor, wiring or computer board.
Regards,
Penguin45.Re: Hotpoint VTD65A Tumble Dryer
Rear sensor/thermostat has been replaced, wiring is fine, so I guess its the board – Do these break a lot? Cost £55 direct from Hotpoint, is that cheap?
When you get the F-13 error code btw, you can’t turn the machine off, using the on/off button, the LCD panel just blinks off for 2 seconds and comes back flashing the error code again, while the drum is still going. Definately a board problem? Dont want to fork out £50 if thats not it!
Cheers
Ed
Re: Hotpoint VTD65A Tumble Dryer
Edward, I have no way of knowing for sure what the problem is. Bear in mind that the NTC device is not a thermostat, it is a negative thermal coefficient sensor (hotter it gets=lower resistance) – they can and do fail – they can also appear to work, but be out of calibration. Computer doesn’t like it, anyways.
If you are going to investigate this yourself, you will need a multimeter and the ability to use it safely and correctly. If you can’t go down that route, a service call is your only choice. Stay safe, power off – or click the link below for a UKW engineer in your area.
There is far better quality product out there.
Regards,
Penguin45.
- You must be logged in to reply to this topic.