Hotpoint dwf 30 test prog ?????

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint dwf 30 test prog ?????

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 29, 2006 at 9:55 am #21241
    Johnnyboy
    Participant

    Help its a bosch new valve fitted but still not wanting to take in water? is there a test prog to check components? Cheers

    September 29, 2006 at 11:28 am #190121
    Martin
    Participant

    Re: Hotpoint dwf 30 test prog ?????

    Johnnyboy wrote:is there a test prog to check components?

    Of if only life and Hotpoint dishwashers were so simple eh? :rolls:

    No, we will have to go about this the hard way I’m afraid! You say you have changed the valve, was there power to it or just a stab in the dark on that I wonder? Is the flood protection system functioning correctly? No rodent damage to wiring? Etc Etc. 😉

    September 29, 2006 at 3:09 pm #190122
    iadom
    Moderator

    Re: Hotpoint dwf 30 test prog ?????

    Martin wrote:

    Of if only life and Hotpoint dishwashers were so simple eh? :rolls:


    As the OP said, “its a Bosch” There is a basic diagnostic test (very basic) for this machine and just 3 error codes.
    Will try to sort some info out for you later, but I am a bit tied up ATM.

    Jim.

    September 29, 2006 at 6:32 pm #190123
    timdowning
    Participant

    Re: Hotpoint dwf 30 test prog ?????

    Power to valve????Check blockage in sump hose. Check the water level microswitch. And press the red float down thus disengaging safety microswitch.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.