- This topic has 3 replies, 3 voices, and was last updated 19 years, 6 months ago by
.
-
Posts
-
Hi all, got a fault on one of these, I can switch on and mains neon comes on but cant select a program (pushing the button does nowt). If I turn machine off then press program button, the program lights light in sequence with each push of the button for a few seconds until the power stored discharges.
I am getting 240v at board thru on/off switch and a neutral thru switch, door switch operating ok, household mains ok.
I thought it must be pcb so I replaced this, but just the same.
Anyone any thoughts?cab
Re: Kenwood d/w KDW12SS fault
Hi Cab,
if the base has flooded the recirculation pump will need drying out, or more likely the heater has an nuetral to earth leakage fault, any earth leakage on these appliances lock out the processer pcb.Bob.
ps. a quick check for a heater fault is to reach in from the front and diconnect the wires just enough room if you have a small hand. 😀
Re: Kenwood d/w KDW12SS fault
It’s a Haier :violent:
Has the base been flooded by any chance ?
Dave.
- You must be logged in to reply to this topic.