- This topic has 4 replies, 4 voices, and was last updated 19 years, 6 months ago by
.
-
Posts
-
hi this machine will do the full wash fine but will not spin will just distribute you hear the motor pick up a little bit then stops and rotates again till the end any ideas?. carbons ok heater ok pressure chamber ok tried empty and full load.
Re: wma31
sounds like OOB is it ok empty is pressure switch ok are the wire from the heater and pressure switch on the board the right way round ( shrouded to the cabinet side) ?
wilf
Re: wma31
hi as in my previous post not oob and module never been off so wires will b round right way.
Re: wma31
I’ve not seen this on a WMA but it could be a stretched belt giving a false OOB condition. This is common on Servis machines. Certainly no harm done by trying a new belt.
Bob
Re: wma31
Helped a friend out recently he had fitted a new drum on a wma31 and then found the same problem.
Fitted a new module to find the same. washing, but on a spin it turned once and continued to distribute.
Problem, he had reversed the two wires on the relay r.hand side (on the board) One insulated the other non insulated terminal.
One side pressure switch the other heater. many years ago I did the same after fitting a new drum. A quick check in the manual put me right. 😳
- You must be logged in to reply to this topic.