ZAN ZWF 1220W Washing Machine

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › ZAN ZWF 1220W Washing Machine

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • October 6, 2006 at 1:10 pm #21467
    DAR01
    Participant

    Prod Code 914780728/00

    Set this machine up on program pumps out for about 5 secs, then does nothing

    Start and Washing led’s lit.

    Every program the same thing happens.

    Any ideas what this fault could be please?

    Is it possible to re configre the control module?

    Mike 🙁 🙁 🙁

    October 6, 2006 at 2:13 pm #190986
    cab
    Participant

    Re: ZAN ZWF 120W Washing Machine

    which lights are flashing and did you count the number of times they each flash. end of cycle light shows first digit, start/pause second digit.

    cab

    October 7, 2006 at 8:50 am #190987
    DAR01
    Participant

    Re: ZAN ZWF 120W Washing Machine

    No lights flashing START and WASHING on constant.

    MIKE 🙁 🙁 🙁

    October 7, 2006 at 12:59 pm #190988
    cab
    Participant

    Re: ZAN ZWF 1220W Washing Machine

    If the board isnt goosed you would expect it to show a fault code, these boards are not configuirable, loads of trouble, drain pumps blow boards. Does the door lock? but again if it failed you would expect it to show a code.

    cab

    October 7, 2006 at 5:15 pm #190989
    wilf
    Participant

    Re: ZAN ZWF 1220W Washing Machine

    valve? machine is supposed to run for a few seconds to clear sump before energising valve

    wilf

    October 9, 2006 at 11:54 am #190990
    DAR01
    Participant

    Re: ZAN ZWF 1220W Washing Machine

    Will not work on spin prog.

    Mike 🙁 🙁 🙁 🙁

    October 9, 2006 at 2:39 pm #190991
    cab
    Participant

    Re: ZAN ZWF 1220W Washing Machine

    drain pump ok, should pump out first.

    cab

    October 11, 2006 at 1:26 pm #190992
    DAR01
    Participant

    Re: ZAN ZWF 1220W Washing Machine

    Update on this one.

    Replaced Control Board, Works Ok.

    Thanks for the input.

    Mike 😛 😛 😛

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.