- This topic has 3 replies, 2 voices, and was last updated 19 years, 6 months ago by
.
-
Posts
-
AEG F50610W (PNC 911 232 545 02) 2 year old dishwasher.
Fills at start of cycle and them immediately pumps out, and gives error code indicating “no water is entering the machine” (which it does OK). Cleaned all filters, checked all hoses and all apear OK. Any suggestions please ?
The heater is has not been working for a week or so as well, but doubt the two faults are connected unless the main electronic control module is faulty. Measured the heater resistance and it is not open circuit, does that indicate a fault with the temp sensor unit in the filter bowl ?
Thanks in anticipation
Re: AEG fills & then immediately pumps out — and heater
sounds like a fault is beening detected by the electronics and aborting the program, could be element but not nesseccarily, any failed component would cause an abort.
cab
Re: AEG fills & then immediately pumps out — and heater
followed some other advice links in the forum and found that the filling problem was caused by a blocked air pressure sense tube – causing the flood control safety to operate – so that is solved and it fills and washes properly but still without the heater working.
will try replacing the temp sense element (bought here) and see if that cures the heater problem.
thanks for the advice
- You must be logged in to reply to this topic.