Bosch Hob ignition

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Bosch Hob ignition

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 12, 2006 at 10:17 am #21622
    kgaf
    Participant

    Hi,
    I’ve got a Bosch Hob (E-NR NET632CEU /04) where the ignition only works for one or two pushs at a time. Any more than that and nothing happens. The spark doesn’t appear to be as powerful/loud as it used to be either. If you wait a few minutes you can get it to work again but only for maybe one or two sparks.

    Any ideas ❓

    Kev

    October 12, 2006 at 11:27 am #191927
    Martin
    Participant

    Re: Bosch Hob ignition

    Remove the burner caps and carefully clean around the sparker to remove any debris and to ensure a good spark contact.

    Do take care not to damage the ceramic sparker (they break very easily)

    DO ISOLATE FROM POWER BEFORE DOING SO FIRST THOUGH :zap:

    If that doesn’t solve the problem you will need to contact a CORGI registered repairer to fix it for you.(see link below to see if there’s one in your area?)

    October 14, 2006 at 2:50 pm #191928
    kgaf
    Participant

    Re: Bosch Hob ignition

    Thanks for reply – So whats likely to be wrong with it ? Have cleaned it but as its same for all four burners didn’t think that was going to make much difference.

    Kev

    October 14, 2006 at 3:23 pm #191929
    gegsy
    Participant

    Re: Bosch Hob ignition

    Hi Kev

    Its more likely going to be an ignition system fault, however as Martin said you will need a gas qualified engineer as his advice didn’t cure 😀

    Greg

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.