- This topic has 2 replies, 2 voices, and was last updated 19 years, 6 months ago by
.
-
Posts
-
hello after a bit of advice with regards to my dishwasher. it goes through complete cycle doing all the things it should heats up and fills up properly,goes through the cycles but stuff in there still comes out unclean. i have cleaned the filters,checked the pump cleaned all the pipes out inlet valve works ok spray arms been cleaned everyhting seems to be working ok but still no joy any ideas would be appreciated thanks
Re: hotpoint first edition not clean
On the assumption that you really have cleaned the filters, the sump under the filters is clean and special attention has been afforded to each and every hole in the spray arms (top & bottom). Then you must have a water supply, lack of sufficient water in the machine, type of problem?
In many cases the crocks on the bottom tray come out clean, but the top tray stuff are the ones that suffer. If that is your experience? Then the problem is insufficient water into the machine. Solution? Get a local independent engineer to service it for you (see link below). 🙂
- You must be logged in to reply to this topic.