- This topic has 0 replies, 1 voice, and was last updated 19 years, 5 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Just a quick one, I am sure its isolated case but its worth checking I had a 1600066 drum support supplied by qualtex (non gen part) as this is what I chose, When fitting last week it wouldnt go through the rear bearing.
Fortunately I had a genuine one also to hand, otherwise I would have been totally done. Just wouldnt fit. Tried a set of bearings on the support outside the machine, no joy definatley wrong size.
I havent reported this yet but I must.
John if you read this, any more reports of the same, and I need to return it. You other guys, if you have any of these check them before you need to fit them. 😳
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.