- This topic has 8 replies, 4 voices, and was last updated 19 years, 5 months ago by
.
-
Posts
-
Have a hotpoint dryer,only 15months old, the rear left of the drum keeps catching the side panel, felt bearings seem ok ?????
Re: hotpoint dryer
Rule No 1 Tim is to give us the model number every time, it really helps us to help you :lesson: 😉 🙂
Re: hotpoint dryer
No CTD30 listed on Partfinder. CTD00, CTD40, CTD80/5 only. TDC30 models are a bit older than 15 months. I think there is a modified ( thicker ) rear seal for these. Also think it advises fitting a couple of washers between drum and back of cabinet. The cabinet is easily pushed out of shape, you can sometimes squeeze it back square to stop this fault as well.
Jim.
Re: hotpoint dryer
CTD Condensor dryers and VTD dryers there is a modified drum which we have been fitting for a few months now cures all the scraping problems, they have been fitted to all dryers since june this year.
Re: hotpoint dryer
Vented dryer 1703622 and Condensor dryer 1703663 there is more clearance between back panel and drum comes whith a new rear seal also.
Re: hotpoint dryer
Thanks for your help once again, 8)
Just checked on latest Partfinder CD Rom and those numbers are listed. 🙂
Jim.
- You must be logged in to reply to this topic.