Whirlpool adg7550 fault code

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Whirlpool adg7550 fault code

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 6, 2006 at 1:59 pm #22313
    vally
    Participant

    Having a nightmare with this dishwasher. Programme keeps stopping I think around the drying cycle and beeps. The led goes to the rinse programme and the start light was flashing constantly. However after a good clean of filters and wash arms a full cycle completed fine. Today though it has stopped again and the light is flashing 3 times – any ideas????

    November 6, 2006 at 6:36 pm #194457
    DentedPorsche
    Participant

    Re: Whirlpool adg7550 fault code

    3 Flashes is a heating fault. Possibilities are the heater, wiring or main pcb.

    DP

    November 7, 2006 at 9:25 am #194458
    vally
    Participant

    Re: Whirlpool adg7550 fault code

    Thanks for reply – any ideas how we check which one it is?

    November 8, 2006 at 6:07 am #194459
    DentedPorsche
    Participant

    Re: Whirlpool adg7550 fault code

    You’ll have to meter the wiring and heater to determine if they’re faulty.
    If they’re ok you’re looking at a slim possibility of the NTC temperature sensor being faulty and at worst the pcb being faulty.
    Parts are expensive so it may be worthwhile getting an engineer in to diagnose properly. If you click on the repairs@ you’ll be able to find someone near you.

    DP

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.