- This topic has 2 replies, 2 voices, and was last updated 19 years, 5 months ago by
.
-
Posts
-
Fixed no spin prob on this lovely(Grrr..) machine by the usual method of a dab of solder on the relay terminal. However when spin has finished the “spin” light remains on instead of advancing to “end” although the door opens. The customer says it stays on “wash” and will not advance to “rinse” and when she changes to rinse prog. manually it will rinse but not advance to spin. Is this likely to be the little board on the front with three switches, three leds, a chip and a ribbon cable going off to each of the other boards?
TIA,
Mike.Re: Servis M6115 programme indicators not move on at any sta
Main module fault not the small board. I remember some bulletin about certain serial number machines should have module changed with the ‘not going to end fault’. I would imagine the fault existed before you sorted out the no spin fault!!!!!
- You must be logged in to reply to this topic.