Candy 1200 Sprint

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #22673
    tona955
    Participant

    Hi,

    I have recently replaced the bushes on this unit as it was not spinning, i have also had to replace the techo, it now spins and seems to work fine but it still fails to complete a full program.

    It just hangs before the drain and spin cycle, i have cleared all pipes and if i manually move the clock a couple of notches it will carry on and complete.
    Any suggestions as to what it might be

    Cheers

    #195793
    Trilobite
    Participant

    Re: Candy 1200 Sprint

    Which programme are you using? Some programmes have automatic “Rinse-Hold”, which stops full of water at the final rinse.

    Try the machine on a Cottons cycle, and make sure any “Rinse-Hold” button is not switched on.

    #195794
    tona955
    Participant

    Re: Candy 1200 Sprint

    Thanks for gettin back to me ..I have checked all switches and they are OK, it seems to stick after almost completing a cycle, stops just before it has to pour more water and then a final spin at this point i have to manually move the dial forward a notch.

    just before it sprays the load and then spin it, thats where it hangs.

    Woudl really appreciate a response on this guys.
    thanks again#

    #195795
    Trilobite
    Participant

    Re: Candy 1200 Sprint

    It might be the programmer that’s playing up.

    Possibly your best bet would be to call an engineer to have it examined.

    Is it still under the guarantee?

    #195796
    tona955
    Participant

    Re: Candy 1200 Sprint

    Hi,

    Well you coudl be rite in saying that as it seesm to be OK now and is washing a full cylce, but the clothes still feel soaken wet…

    I just spin them again and that sorts it out.better than what it was.

    not sure what else i can check..

    cheers

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.