Whirlpool ADG7540

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool ADG7540

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 20, 2006 at 7:18 pm #22728
    effzedarr
    Participant

    Hi folks ,customer complaining of dirty dishes & not heating up but going thro’ wash. Checked heater & wiring thro’ to pcb all ok! Tested on 40c wash, fills washes releases detergent washes for about 5mins then empties & starts agian ,but no flashing lights for fault codes, Iguess it could be the pcb but I havn’t had much to do with these m/cs so is there anything else to look for ?
    cheers Chris..

    November 20, 2006 at 8:28 pm #195980
    gegsy
    Participant

    Re: Whirlpool ADG7540

    Hi
    Ive had a similar fault where customer had ordered heater and module to find that after fitting, still no heat.
    Turned out to be a faulty NTC, and again showed NO fault code 😀

    Greg

    November 20, 2006 at 8:49 pm #195981
    effzedarr
    Participant

    Re: Whirlpool ADG7540

    Cheers Greg ,but what is a NTC? As I said I’m not fimiliar with these m/cs, I guess a NTC is cheaper than a PCB, any part#?
    cheers Chris..

    November 20, 2006 at 9:04 pm #195982
    gegsy
    Participant

    Re: Whirlpool ADG7540

    Hi
    NTC is p/no 48122868035 around £20. This is a twist fit situated below filters and protrudes vertically up out of sump area, can’t miss it, its white and looks like a bullet.
    The NTC kit will come with new wires and some crimping may be required.
    Make sure you put some insulating tape along the edge of the drip tray as they are razor sharp 😯

    Greg

    November 20, 2006 at 10:37 pm #195983
    effzedarr
    Participant

    Re: Whirlpool ADG7540

    Thanx for that Greg, I best stock up on Elastoplast to be on the safe side 🙁
    Chris..

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.