WMA35 – Wash Cycle getting stuck @ end

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › WMA35 – Wash Cycle getting stuck @ end

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 26, 2006 at 10:29 pm #22884
    uzy
    Participant

    Hi

    My washing machine gets intermittently stuck on the last bit of the wash cycle. It doesnt drain and therefore the spin doesnt happen either.

    Any tips/ideas would be greatly appreciated.

    Also advice on where to buy parts, in case, especially if its the electric circuit board that controls the cycle, would be good.

    Thanks in advance

    Rgds
    Uzy

    November 26, 2006 at 11:35 pm #196429
    aqualectric
    Participant

    Re: WMA35 – Wash Cycle getting stuck @ end

    You can check the sump hose/ filter first for blockages – accessible through the small cover plate on the rear of the machine. If your machine is connected to a sink trap be sure to check that the washing machine outlet hose and the nozzle it fits to are clear.
    If no blockages are found, then it could be the pump or control PCB at fault. It is advisable at this point to call an engineer. You will risk wasting money if you buy expensive parts you may not need. Click the banner below for an engineer in your area.

    Always – ensure power is off before any inspection.

    Steve.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.