Getting rid of the “Bleep”

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Getting rid of the “Bleep”

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • November 30, 2006 at 5:32 pm #22999
    rioone
    Participant

    Hi I have recently purchased a Bosch washing machine WAE 2816528GB.
    It’s a brill machine except for the Bleep sounding at the end of every program… I often leave the machine on when I am at work & come home to find it has been bleeping for hours…Is there any way that I can stop this Bleep :rolls:

    November 30, 2006 at 11:29 pm #196744
    gegsy
    Participant

    Re: Getting rid of the “Bleep”

    Hi
    That model you supplied is mad 😆 I am going to assume WAE28162GB/03 8)
    The sound selection should be in your user manual AFAIK but just incase, check your email 😉
    Greg

    December 1, 2006 at 6:58 pm #196745
    rioone
    Participant

    Re: Getting rid of the “Bleep”

    😮 Hi Greg WOW what a prompt reply…
    Thanks a lot~ the instructions look a bit complicated but I’ll give it a go~ Anything to get rid of that annoying Bleep….
    Regards Lizzy 😉 😀

    December 1, 2006 at 11:01 pm #196746
    SERVICENORTHWEST
    Participant

    Re: Getting rid of the “Bleep”

    HI ROONIE 😀 , IF YOUR NOISE FAULT IS STILL BUGGING 🙁 YOU PLEASE MAIL BACK AND I’LL GIVE YOU MY PHONE NUMBER AND TALK YOU THROUGH TURNING THE TONE DOWN OR OFF. COLIN 😀

    December 1, 2006 at 11:47 pm #196747
    iadom
    Moderator

    Re: Getting rid of the “Bleep”

    Hi Colin, PM me and I will tell you how to turn the CAPS lock off. 😉

    Jim.

    December 2, 2006 at 10:53 am #196748
    gegsy
    Participant

    Re: Getting rid of the “Bleep”

    Hi Colin
    I see you appear not to be a trade member. If you should require trade access then please contact site admin to gain more access to the site 😀

    Greg

    April 18, 2009 at 7:50 pm #196749
    sibstar
    Participant

    Re: Getting rid of the “Bleep”

    Hi,

    I recently attempted repair to a Bosch WAE28162/09 washing machine. All the lights were illuminated. I traced the fault to worn out carbon brushes and replaced them. However the lights on the display are all still illuminated almost like the machine is locked in a fault mode and won’t let me do anything with it.
    Can anyone help and tell me how to reset the machine as I’m sure it was just the brushes at fault??

    thanks

    Simon

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.