zan zwf1220 carbons

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › zan zwf1220 carbons

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 9, 2006 at 7:15 pm #23247
    streetlighter
    Participant

    Hi all
    was a post on this back in april but I wonder if any one has a update.
    can you fit 50265481007 which looks different, or connect cbn9041 which looks like thc correct carbon with the tag 3/4 down the side facing upwards.

    Ta

    Paul

    December 9, 2006 at 7:53 pm #197505
    Martin
    Participant

    Re: zan zwf1220 carbons

    I don’t know about Connect stuff but in terms of Qualtex brushes there are only 3 types needed to fit the entire Zanussi range dependant on whether a SOLE or CESET motor is fitted? CAR53, CAR65 or CAR89 cover the lot!

    Carry all 3 to be sure. 😉

    December 10, 2006 at 8:13 am #197506
    Phidom
    Participant

    Re: zan zwf1220 carbons

    Not quite Martin, some of the Jetsystem machines had AEG motors.

    December 10, 2006 at 8:44 am #197507
    funkyboogy
    Participant

    Re: zan zwf1220 carbons

    you can get them from ht maddocks…cant remember the part no of hand will post later…ive used them a few times….you get them with the carbon brush kit from them…very good kit…
    pulled me out a few holes….

    December 11, 2006 at 6:22 pm #197508
    streetlighter
    Participant

    Re: zan zwf1220 carbons

    Just an update
    went back today and fitted 50265481007 no probs at all 😆
    by the way these also fit hotpoint wma macines if you reuse the hotpoint holder 😀

    Thanks

    Paul

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.