Zanussi ZWF1440 PCB p/n 973914517516006

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWF1440 PCB p/n 973914517516006

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 12, 2006 at 6:30 pm #23319
    GCK
    Participant

    This machine blew a PCB due to contaminated carbon brushes. The new PCB has the terminals for the plug at J6-1 and J6-2 taped over. Do I connect these grey leads together?. I blew the first replacement board by removing the tape and plugging in the leads as on the original board!

    December 12, 2006 at 7:15 pm #197737
    iadom
    Moderator

    Re: Zanussi ZWF1440 PCB p/n 973914517516006

    Duplicate post in General Forum deleted, if you post in two places it only gets messy with people replying to two different threads. 😉

    Jim.

    December 14, 2006 at 3:05 pm #197738
    cab
    Participant

    Re: Zanussi ZWF1440 PCB p/n 973914517516006

    hi the most probable reason that the replacement board has blown is because you havent rectified the fault. Havent had motor brushes blow boards. The most common reason is a short on drain pump. The tape over the terminals is just to ensure its new, I believe the orientation of the plug socket has changed but that is all. A short circuit door lock is also a possibility.

    cab

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.