F&P GW709AU

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › F&P GW709AU

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 16, 2006 at 11:39 pm #23421
    hugoismydogsname
    Participant

    Hi,

    My GW709AU F&P is pulsing water in for about 10 seconds, then the pulsing stops and a constant beep starts.

    I have turned off/on – no luck.

    I have run diag report and get 00101011.

    If it is the tube from the airbell at the bottom of the tub (i got this from another posting) would you kinldy tell/show me what this airbell looks like or where it is.

    Many thanks and regards.

    December 17, 2006 at 1:02 am #198064
    Penguin45
    Participant

    Re: F&P GW709AU

    Out of Balance switch fault. Check function, connectors for corrosion etc, check bias spring connected casing to tub.

    Regards,
    Penguin45.

    December 17, 2006 at 1:12 am #198065
    hugoismydogsname
    Participant

    Re: F&P GW709AU

    Thanks Penguin45.

    Forgove my ignorance, what does “check function” mean and which connectors (where are they) need to be checked?

    Thanks again.

    December 17, 2006 at 1:38 am #198066
    Penguin45
    Participant

    Re: F&P GW709AU

    OK – test meter to check whether or not the switch mechanism is making and breaking the circuit. Corrosion is pretty obvious – get everything cleaned off, replace connectors if really bad. Two screws at the back of the console panel will allow you to remove the top deck and see everything – the OOB switch is the one with the pendulum arm attached.

    Stay safe – power off.

    Regards,
    Penguin45.

    December 17, 2006 at 4:53 am #198067
    hugoismydogsname
    Participant

    Re: F&P GW709AU

    Thanks Penguin45. I’ve got it working.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.