- This topic has 1 reply, 2 voices, and was last updated 19 years, 4 months ago by
.
-
Posts
-
I have an indesit DV620BKUK dishwasher that will not operate.
All I get is the red power on lamp and then the next green lamp above the first stage rapidly flashing. I did get it to start its cycle once, it went through its initial stages then reverted to the previous sit and flash mode ❓ . Indesit will not give out any tech info and we no longer have the manual. Any advice would be most welcome.
Thanks
Jim 😥Re: Indesit dv620bkuk
If you mean that the first neon from the left is flashing then that signifies that you have water in the base. It could be an internal leak or due to using 3 in 1 or 4 in one tablets, these can cause over foaming and flood the base.
As this is an integrated machine you will need to pull it out, hoping that whoever fitted had more than the usual single brain cell that most kitchen fitters are blessed with. Then place some towels on the floor and tilt the machine backwards or to either side. If you get water flowing out from underneath, this will confirm a flooded base. You could then try the machine again, if the fault occurs again fairly quickly then you need to find the source of the leak. Plug out at all times, if you need expert help try the link at the bottom of this post.Jim.
- You must be logged in to reply to this topic.