Hotpoint aquarius wma32 1200 spin

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Hotpoint aquarius wma32 1200 spin

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • December 27, 2006 at 12:40 pm #23627
    Bacardi
    Participant

    Gentlemen,
    I have a Hotpoint aquarius wma32 1200 spin.

    It keeps cutting out after 10 minutes operation.It blows the trip swith and cuts out every thing. I have tried turning on the w.mach. making sure nothing else
    is turned on same result.
    Does not sem to have blocked pipes.

    would check the filter but cannot find it.

    do you think it is overheating -thermostat if there is one,.?

    Or is it an electrical fault
    Do I need to call an engibeer aor can it be fixed by myself


    any help would be appreciated


    best regards


    Bacardi 😆

    December 27, 2006 at 12:44 pm #198867
    Simon46
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    I would recommend an engineer with the relevant diagnostic equipment. Have a look at Repairs@ for one.

    Regards
    Simon

    December 27, 2006 at 1:24 pm #198868
    Bacardi
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    thks but want to investigate the problem and try and fix myself. the enginneers in ireland are puite expensive
    regards

    Bacardi

    December 27, 2006 at 8:10 pm #198869
    Penguin45
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    Heater most likely culprit – it isn’t on initially, cuts in after a few minutes operation.

    Stay safe, power off if investigating.

    Regards,
    Penguin45.

    December 27, 2006 at 8:24 pm #198870
    Bacardi
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    ok thks.

    any advise in how to investigate heater?

    thks again

    December 27, 2006 at 8:47 pm #198871
    Penguin45
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    Can’t walk you through it, Bacardi – see Forum Rules above. A typical heater should show a resistance of 25-35 ohms and no earth leakage when tested with a megger.

    Regards,
    Penguin45.

    December 27, 2006 at 8:55 pm #198872
    Bacardi
    Participant

    Re: Hotpoint aquarius wma32 1200 spin

    ok thanks for taking the time to answer and pointing me in the direction

    best regards

    Bacardi

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.