Creda Edcs51 doing strange things

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Creda Edcs51 doing strange things

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 30, 2006 at 6:30 pm #23703
    staples
    Participant

    Hi Please help, I have a creda cooker which is about 5 years old, the fan element blew last week so I ordered a replacment ensuring it was the correct one. I fitted the element turned the oven on and all seemed fine. I then later turned the oven on to do some cooking and after about 25 min it tripped the mains circuit. Now whenever i switch the cooker isolating switch on the fan runs and the oven light comes on. When i ten turn the oven temp on the element turns on but seems to be on full power no matter what tenp I want it on(burning lots of food at the mo) Any help would be greatly recieved.

    Thanks

    December 30, 2006 at 7:04 pm #199063
    Penguin45
    Participant

    Re: Creda Edcs51 doing strange things

    Earth fault on new element possible, it can then by-pass the thermostat and run full on all the time.

    Two elements available for this one:
    1200w, 165mm diameter – 6203335
    1800w, 200mm diameter – 6203338

    Other possiblilty is the thermostat has failed – contacts welded shut is a likely cause.

    Main oven thermostat – 6222155

    Or both……. Either way, you’re going to have to go circuit testing to figure it out. Power off, of course.

    An email to spares@ukwhitegoods.co.uk for prices and ordering on any of the above.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.