Hotpoint DWF50 Sticking

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint DWF50 Sticking

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 3, 2007 at 10:56 am #23778
    WhiteVanMan1
    Participant

    Happy New Year all. I have a DWF50 which is sticking after a couple of minutes with both the fast 40 deg and delicate 50 deg led’s flashing. I suspect possible water pressure problem as the machine is connected to the hot supply, which was always likely to cause a problem. Can anyone help? Thank you.

    January 3, 2007 at 11:01 am #199343
    iadom
    Moderator

    Re: Hotpoint DWF50 Sticking

    From page 3 of the Known Error codes thread. 😉

    Hotpoint DWF 50 & DWM55 also FDW60 dishwashers

    Led 1 Intensive
    Led 2 Normal
    Led 3 Eco
    Led 4 Fast
    Led 5 Prewash
    Led 6 Delicate

    3…..Overflow (water in base)-Leak from water line
    4…..Solenoid valve fault -Inlet valve,connections
    5…..Thermistor circuit-Thermistor c/w timer
    6…..Timeout heating-NTC detached from casing
    3+4.Timeout draining-Pump connections,blockage,module
    4+5.Timeout filling-Tap off,Inlet valve,connections,timer,water turbine
    3+5.Circulation pump not working- pump,connections,capacitor,module
    3+5.Filters blocked-Mesh plate,filter or microfilter,pressure sensor
    1+4.Software recognition error-Timer not programmed,wrong keypad
    4+6.Heating circuit-heater,connections,module,relay
    3+4.Hardware version (timer)

    Heaters are prone to failure on these so that would be my first point of investigation.

    Jim.

    January 4, 2007 at 8:27 am #199344
    WhiteVanMan1
    Participant

    Re: Hotpoint DWF50 Sticking

    Cheers Jim, Thanx for the reply, I’ll check it out.
    Steve

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.