Blomberg 1301 not spinning

Re: Blomberg 1301 not spinning

Should be what you want……….

http://www.ukwhitegoods.co.uk/modules.p … t=blomberg

Penguin45.

Re: Blomberg 1301 not spinning

I have a similar problem: the machine won’t spin on the wash cycle, but after the wash has completed, setting it to spin works 90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time. The reference talks about an out of balance problem. Is this a sensor I can check / change?

Re: Blomberg 1301 not spinning

Still can’t get the machine to spin. Does the out of balance circuit reset each time the machine is started?
I’ve:
Cleaned the grommet and pressure bell
Checked the motor brushes – they’ve still got over an inch of movement.
Checked the ‘filter’ at the front – but in any case the machine is empty

Is there anything else I can check?

Re: Blomberg 1301 not spinning

Problem solved! I’ll post the answer for future ref.
It all started with the machine starting to bounce all over the place – eventually diagnosed to completely worn out shock absorbers/stabilisers. New pair bought from UK Whitegoods ordered and fitted, then this problem of not spinning.
Taking the top off to look at the electronics, I noticed that the drum wasn’t horizontal, the back was lower; the drum had come off the rear support spring with the vibration. Hanging it back on has cured the no spin problem. The reason being it seems, the drum drains from a hole in the centre, but the sensor for being empty of water (the grommet/pressure bell) and so ready to spin is at the rear. With the drum dropped and slightly lower at the back, even though the pump had emptied as much as it could, the surface of the sensor was still just under water, so not allowing the spin. (Also had to reconnect some earth wires which had also been pulled off the drum)