Zanussi Dishwasher IWMS

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi Dishwasher IWMS

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 15, 2007 at 11:42 pm #24166
    nationalhomecare
    Participant

    Hi Folks!
    Im being nosey.
    Whats a IWMS like to do on a Zanussi dishwasher, I keep hearing things about them failing and being a pig to do, any common problems?? Whats its purpose, ie water softening, level control, collecting crap etc??
    As I say, i’m just being nosey and am intruiged about it, I don’t intend to start doing them!
    Any information greatly appreciated.
    Steve 🙂

    January 16, 2007 at 12:04 am #200932
    Penguin45
    Participant

    Re: Zanussi Dishwasher IWMS

    If it takes you more than 40 minutes, you’re doing it wrong…….. Two big hoses, couple of skinny ones, couple of screws and drop the valve into place. I usually spend more time educating the customer in the art of getting the heavy stuff off the plates (“It’s a dishwasher, madam, not a waste disposal unit……”) than fitting the thing.

    Chris.

    January 16, 2007 at 6:37 pm #200933
    nationalhomecare
    Participant

    Re: Zanussi Dishwasher IWMS

    Thanks Chris,
    Sounds a bit like that water management system that BSH used on the SPS series?! Sounds like they get gunged up like ours do then. 😆
    Seen something that would of distresed you today, a cocker spaniel tearing to shreds a ‘Persil’ Mumble the Penguin 🙁
    Regards
    Steve 😉

    January 17, 2007 at 12:30 am #200934
    eastlmark
    Moderator

    Re: Zanussi Dishwasher IWMS

    Remember though there is a valve/antiflood mod that cures most lock out problems, takes longer to fit though.

    January 17, 2007 at 5:56 pm #200935
    tanner
    Participant

    Re: Zanussi Dishwasher IWMS

    easy (and let me say it) peasy

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.